Painstaking control over every phase is what makes our way of doing things stand out. To do this we have the most advanced ICT resources on the market. Every technician has their own hardware for collecting and consulting data. All the data collected speeds up repairs by using information from spindles repaired in the past.
We work closely together with the top global manufacturers, and have access to original spare parts. We cover practically all industries (aeronautical, automotive, optical and so on). Our technological resources and highly-qualified staff have earned us a leading position in Europe and made us a benchmark at global level.
1 Receipt & identification
When the spindle is received at our facilities, it is identified and entered into the system, and it is assigned a project number for traceability.
We thoroughly inspect the spindle, analysing the condition in which the spindle was received; thus we can analyse the possible fault before dismounting.
We fully dismount the spindle, taking special care not to damage any component and separating and identifying each one of them. We digitally note and store the data relating to the condition of the parts.
We thoroughly clean each component, ensuring they are in the best condition for later inspection of its geometry.
5 Geometrical inspection
We carry out a dimensional and geometrical inspection of all the parts. All areas of our facilities have a controlled and constant temperature to ensure all measurements are accurate.
6 Design & Manufacture
We design and manufacture any component that can be repaired or replaced in our facilities; the technical department designs a plan for each specific repair job.
7 Report & Quotation
We analyse all the data in a multi-departmental meeting and prepare a report and a specific quotation for the customer.
We plan the assembly once the customer has accepted our quotation in our “clean assembly room”.
We balance the spindle to the highest level defined in standard ISO- 10816.
10 Running-in test
We run-in the spindles using the original parameters, monitoring bearing and motor temperature as well as the vibration values at all times, ensuring it operates correctly once installed in the machine.
11 Final inspection
When the spindle is received at We carry out a thorough analysis of all the values that determine the correct operation of the spindle, this task is carried out by the same technician that previously analysed and disassembled the spindle.
We package the spindle in non-reactive paper in specific packages for the protection of the spindle during transport. All the reports and instructions relating to the repair are included.